Alexenko O. The development of the methods of calculation and investigetion of the blades pump working process.

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0406U001538

Thesis Registration Form

0406U001538.pdf

Applicant for

Specialization

  • 05.05.17 - Гідравлічні машини та гідропневмоагрегати

30-03-2006

Specialized Academic Board

К55.051.03

Essay

Purpose - the elaboration of the complex mathematical model of the centrifugal pump working process hydraulic subsystem for the calculation experiment development in the pump building. Methods: methods of mathematical modelling, block-hierarchical principle as an element of the system analyse, linearization and iteration methods of calculation mathematic. Results: elaborated centrifugal pump complex model as difficult system of the flow in pump elements, which influence each other. The method of energy characteristics prediction on the first stage of designing was developed. Using of this method during choosing of the pump schema allow to decrease influence of the subjectivity. Area of use: pump building industry.

Read more

Files

Aref.doc

Tитул.doc

Введение.doc

Додаток А.doc

Додаток Б.doc

Додаток В.doc

Змiст.doc

Розд_1.doc

Розд_2.doc

Розд_3_1.doc

Розд_3_21.doc

Розд_3_22.doc

Розд_3_23.doc

Розд_3_24.doc

Розд_3_3.doc

Розд_4.doc

Сокращения.doc

Similar theses

0421U101047

Moskalenko Vladyslav V.

Improving the operational characteristics of type D pumps by reducing the intensity of pressure pulsations in their flowing part

0420U100279

Chmuzh Yaroslav V

Substantiation of the parameters of low-speed high-torque hydraulic motors based on cylinders.

0420U100282

Moloshnyi Oleksandr M.

Influence of the inlet device construction of the sealless close coupled pump with a hollow shaft on its working process and characteristics

0420U100281

Panchenko Vitalii O.

Improve the technical level of the torque flow pump by improving the geometry of the impeller

0420U100280

Miroshnychenko Dmytro

Energy efficiency upgrading of pneumatic units created on the basis of vortex expansion machines