Babenko Y. Development of directive procedures for processing of friction surfaces or aircraft actuated parts by quality limit parameters.

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0401U001705

Thesis Registration Form

0401U001705.pdf

Applicant for

Specialization

  • 05.07.04 - Технологія виробництва літальних апаратів

01-06-2001

Specialized Academic Board

Д 64.062.04

National Aerospace University "Kharkiv Aviation Institute"

Essay

The aim of the thesis is to develop the design principles of directive procedures for processing of friction surfaces to secure required quality of aircraft actuated parts. The technique is developed subject to finishing processing and friction surface coating at pre-production phase and is based on manufacturing influence upon quality limit parameters of actuated parts. The criteria of synthesis of engineering procedures are also worked out to obtain a limit carrying capacity, durability and temperature efficiency of items involved the outcomes are applied at manufacturing the landing gear assemblies of An-70 and An-140 airliners as well as at extension of landing gear service life of An-26, An-30 and An-32 airlines.

Read more

Similar theses

0407U004775

Voytenko Sergey Anatolievich

Research of processes of the factors of a technological heredity formation at gas-turbine engines parts manufacturing from titanium alloys

0407U000863

Polischuk Elena Alekseevna

Technology of inertial method of utilization of aviation ammunition taking into account safety criterion

0407U000449

Melnikov Sergij Mihailovich

Methods of technological tolerance standartization in honeycomb production for airspace production technique

0406U002975

Melnychuk Olexandr P

Modelling the Technological Processes of Hydrodynamic Trailing Edge Punching for Air System Pipelines in the Aircraft

0406U000121

Zamkovoy Vasyliy Evgeniovich

Improvement of procedures of forming internal cavities of cooled blades of gas turbine engine