Fedchenko N. Improvement of aluminium-based alloys quality quality using electrohydropuls treatment - Manuscript

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0402U001074

Thesis Registration Form

0402U001074.pdf

Applicant for

Specialization

  • 05.02.01 - Матеріалознавство

21-03-2002

Specialized Academic Board

Д 64.059.01

Kharkiv National Automobile and Road University

Essay

Subject of research: alloys based on aluminium Research object: the aluminium-based alloys Aim of the-work: the analysis of influence of parameters EHPT on structural formation and characteristics of aluminium-based alloys Methods of research: metallography, X-ray spectral, X-ray structural analysis Theoretical aid practical results: it. was settled the general appropriateness of influence of parametres EHPT on the structural characteristics of alloys, selected the most effective scheme of EHPT, achieved the level of property in utility waste alleys which is regulated of DCTU News of results: it was settled appropristeness of structural formation in alloys after EHPT Degree of introduction; the work results aге tested at the joint-stock company "Oil and filter-equipment, work", Mikolaiv Sphere of application machine-building and metalurgical works

Read more

Files

Glava 2.doc

Glava 3.doc

Glava 5.doc

VVED.doc

aref.doc

glawa 1.doc

glawa 4.doc

авто_укр.doc

Similar theses

0523U100235

Yulisa G. Chabak

Development of the scientific basis of enhancing the operational properties of alloyed cast irons by improving the chemical composition and applying highly concentrated energy sources for surface treatment. – Qualifying work as а scientific report

0423U100094

Romanenko Yaroslav M

Formation under high pressure of tool PCBN composites with homogeneous structure and increased damping capacity

0523U100002

Trostianchyn Andrii

The concept of hydrogen treatment to improve the structural-phase state and properties of functional materials based on alloys of rare earth and transition metals

0421U103868

Voloshyna Liudmyla V.

Higher wear resistance of an oil gear pump for tractor diesel engines

0521U102025

Rybalko Ivan M.

Experimental, theoretical and technological basics of hardening products with the use of modifying agents