Bagmet M. Development of complex technologies to increase of life cycle of the aircraft engines parts and groups.

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0403U001762

Thesis Registration Form

0403U001762.pdf

Applicant for

Specialization

  • 05.07.04 - Технологія виробництва літальних апаратів

16-05-2003

Specialized Academic Board

Д 64.062.04

National Aerospace University "Kharkiv Aviation Institute"

Essay

Life cycle increasing of aircraft engines parts. The influence of different technologies on quality, physical-mechanical characteristics of surface layer of aircraft engines parts. The process of magnet-abrasive machining of parts with coating and without coating. The recommendations for conducting of the technological processes production of aircraft engine blades with the use finishing magnet-abrasive machining. Is introduse at Motor-Sich JSC (annual benefit - 30000 $).

Read more

Files

ВВЕДЕНИЕ.doc

ЛИТЕРАТУРА (ДИССЕРТ.).doc

ОБЩИЕ ВЫВОДЫ.doc

П Р И Л О Ж Е Н И Е.doc

Раздел 1.doc

Раздел 2.doc

Раздел 3.doc

Раздел 4.doc

Раздел 4.doc

Рис.2.10 (теория).doc

Рис.2.12(теория).doc

Рис.2.9 (теория).doc

Рис.3.2 (факторы, вл. на предв.обр.).doc

СОДЕРЖАНИЕ.doc

Таблица 1 Прилож.(классиф.покр.).doc

Таблица 2 Прилож. (обр.покр.).doc

Таблица 7 Прилож.(способы предв. обраб.поверх.).doc

Титульный лист.doc

ЭКОНОМИЧЕСКОЕ ОБОСНОВАНИЕ ВЫБРАННЫХ МЕТОДОВ.doc

автореферат укр..doc

рис.2.4 (теория).doc

рис.3.1(способы подг. поверх.).doc

Similar theses

0407U004775

Voytenko Sergey Anatolievich

Research of processes of the factors of a technological heredity formation at gas-turbine engines parts manufacturing from titanium alloys

0407U000863

Polischuk Elena Alekseevna

Technology of inertial method of utilization of aviation ammunition taking into account safety criterion

0407U000449

Melnikov Sergij Mihailovich

Methods of technological tolerance standartization in honeycomb production for airspace production technique

0406U002975

Melnychuk Olexandr P

Modelling the Technological Processes of Hydrodynamic Trailing Edge Punching for Air System Pipelines in the Aircraft

0406U000121

Zamkovoy Vasyliy Evgeniovich

Improvement of procedures of forming internal cavities of cooled blades of gas turbine engine