Moroz K. Development of modified by disperse fillers epoxycomposites for increasing the resource of exploitation of technological equipment

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0412U006823

Thesis Registration Form

0412U006823.pdf

Applicant for

Specialization

  • 05.02.01 - Матеріалознавство

14-12-2012

Specialized Academic Board

К 67.111.01

Ministry of Education and Science of Ukraine

Essay

Dissertation is devoted to investigation of polymer-composite materials based on epoxy oligomer ED-20 with fillers of different physical and chemical nature. The aim of the article is to establish the main regularities of the polyvinyl alcohol solution on the structure formation process and properties of epoxycomposites. Found that the method of surface modification of disperse particles can widely regulate physical and mechanical properties and performance of materials. Based on the results new materials and coatings with enhanced performance are created. Obtained materials have been tested in pilot conditions at the "Husyatyn GCS"

Read more

Files

aref.doc

dis.doc

dis.doc

Similar theses

0524U000117

Nataliia Y. Imbirovych

Mechanisms and patterns of plasma-electrolytic synthesis of biocoatings based on titanium alloys

0523U100235

Yulisa G. Chabak

Development of the scientific basis of enhancing the operational properties of alloyed cast irons by improving the chemical composition and applying highly concentrated energy sources for surface treatment. – Qualifying work as а scientific report

0423U100094

Romanenko Yaroslav M

Formation under high pressure of tool PCBN composites with homogeneous structure and increased damping capacity

0523U100002

Trostianchyn Andrii

The concept of hydrogen treatment to improve the structural-phase state and properties of functional materials based on alloys of rare earth and transition metals

0421U103868

Voloshyna Liudmyla V.

Higher wear resistance of an oil gear pump for tractor diesel engines