Makovetsky V. Perfection of technologies and equipment or hot volumetric punching of thin-walled from titanium of alloys with an increased exatitude of geometric performances

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0403U000521

Thesis Registration Form

0403U000521.pdf

Applicant for

Specialization

  • 05.03.05 - Процеси та машини обробки тиском

23-01-2003

Specialized Academic Board

Д 12.105.01

Donbass State Engineering Academy

Essay

Processes of punching forging. Increase of technological parameters of processes of deriving forging of the space form from titanium of alloys. Methods of a research and equipment numerical mathematical modelling, experiments in laboratory and industrial conditions. Theoretical and practical outcomes mathematical models and software on the automized account and designing of technological processes of forging and straightening of a space construction. The novelty is appreciated influence of a modification of initial parameters of process of punching to an exactitude of geometric performances forging of detailses such as boxes and boards with ledges. The degree of introduction the and boards with ledges. The degree of introduction the technological and constructional recommendations for perfecting processes of forging and designing of equipment for manufacturing forging of a space configuration from titanium of alloys (is the act of introduction and help about use). An orb of use design subdividings of the metallurgical enterprises and research institutes.

Read more

Files

aref--aref.doc

dissert--PrilogA.doc

dissert--PrilogB.doc

dissert--PrilogD.doc

dissert--PrilogV.doc

dissert--Razdel1.doc

dissert--Razdel2.doc

dissert--Razdel3.doc

dissert--Razdel4.doc

dissert--Razdel5.doc

dissert--Razdel5.doc

dissert--Soderg.doc

dissert--Spislit.doc

dissert--Titul.doc

dissert--Vivodi.doc

dissert--Vveden.doc

Similar theses

0424U000044

Andrii Shtuts

Improvement of rolling stamping processes on the basis of modeling of the mechanics of forming blanks

0421U103937

Glazko Vladyslav V

The improvement of the design of the elastomeric compensator for eccentric loads of the "press-die" system with parallel transfer of the technological force vector

0421U103225

Mishchenko Oleksii V

Development of the theory of formation and reduction of the transverse wall thickness variation of cold-rolled tubes from titanium alloys

0521U101599

Borovik Pavel Vladimirovich

Development of theoretic foundations and improvement of technology and equipment of separation operations processes in rolling production

0521U101565

Hrudkina Natalia

Development of energy methods for the analysis of technological modes and improvement the processes of precise volumetric stamping by extrusion.