Dvorzhak A. Perfection of technologies and equipment for realization of flatting of billets with a difficult structure of cross section

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0404U000190

Thesis Registration Form

0404U000190.pdf

Applicant for

Specialization

  • 05.03.05 - Процеси та машини обробки тиском

19-12-2003

Specialized Academic Board

Д12.105.01

Essay

Flatting of billets. Increase of technological parameters of flatting. Methods of a research and equipment - the numerical and statistical mathematical simulation, experiments in conditions of laboratory also experimental-commercial productions. Theoretical and practical outcomes - mathematical models and software on an automated of technological modes of flatting. The novelty - is appreciated influence of a modification of initial parameters of flatting on an accuracy of geometric performances and mechanical properties of billets. The degree of introduction - recommendation at the choice of technological modes and equipment for flatting (is the acts of introduction). An orb of use - design staffs of the machine-building enterprises and research institutes.

Read more

Files

aref.doc

prilozh--Б.doc

prilozh--ПриложениеА.doc

raz1--RAZ1.DOC

raz1--risun-1.doc

raz2--RAZ2.DOC

raz2--ris_2.doc

raz2--ris_2.doc

raz3--raz 3.doc

raz3--ris_3.doc

raz4--Raz_4.doc

raz4--ris_4.doc

raz5--Раз_5.doc

raz5--Рис5.doc

raz6--Raz_6.doc

raz6--Ris_6.doc

spisok_lit.doc

Введение.doc

Выводы.doc

СОДЕРЖАНИЕ.doc

Титул.DOC

Similar theses

0424U000044

Andrii Shtuts

Improvement of rolling stamping processes on the basis of modeling of the mechanics of forming blanks

0421U103937

Glazko Vladyslav V

The improvement of the design of the elastomeric compensator for eccentric loads of the "press-die" system with parallel transfer of the technological force vector

0421U103225

Mishchenko Oleksii V

Development of the theory of formation and reduction of the transverse wall thickness variation of cold-rolled tubes from titanium alloys

0521U101599

Borovik Pavel Vladimirovich

Development of theoretic foundations and improvement of technology and equipment of separation operations processes in rolling production

0521U101565

Hrudkina Natalia

Development of energy methods for the analysis of technological modes and improvement the processes of precise volumetric stamping by extrusion.