Melnik S. Elaboration of roll pass design technique for heavy sheet piles rolling

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0407U003877

Thesis Registration Form

0407U003877.pdf

Applicant for

Specialization

  • 05.03.05 - Процеси та машини обробки тиском

21-09-2007

Specialized Academic Board

К 08.231.01

Iron and Steel Institute of Z.I.Nekrasov National Academy of Sciences of Ukraine

Essay

Process of hot rolling of the large П-figurative profile of a difficult configuration. Learning of a forming of metal depending on the geometrical sizes of stock material, working tool and development on the based results new method of account of calibrations of rolls for rolling large groove-and-tongue of piles of the П-figurative profile of a new construction. The new method of application for sizing initial stock material is designed, is fixed, that at rolling large groove-and-tongue of piles such as "Larsen", for to provide of performance of the latch molding of elements on a finished section it is necessary to utilize an identical bevel flange of beam in all calibers. The new way of shaping latch of elements is proposed, which one allows to monitor height latch of an element before warp him in a try-gauge. It enables to receive exact matching of the form of a strip with form in a try-gauge, to provide performance latch of elements on a finished section of the necessary form and sizes.

Read more

Files

Dis--1Титульный лист.doc

Dis--2_Содержание.doc

Dis--3_ВВЕДЕНИЕ.doc

Dis--4_Раздел 1.doc

Dis--5_раздел 2.doc

Dis--6_РАЗДЕЛ 3.doc

Dis--7_раздел 4.doc

Dis--8_раздел 5.doc

Dis--9_раздел 6.doc

Dis--ОСНОВНЫЕ ВЫВОДЫ.doc

Dis--Список использованных источников.doc

Dis--сс_Приложение А.tif

Dis--сс_Приложение Б_1.tif

Dis--сс_Приложение Б_2.tif

Dis--сс_Приложение В.tif

aref-Мельник.doc

Similar theses

0424U000044

Andrii Shtuts

Improvement of rolling stamping processes on the basis of modeling of the mechanics of forming blanks

0421U103937

Glazko Vladyslav V

The improvement of the design of the elastomeric compensator for eccentric loads of the "press-die" system with parallel transfer of the technological force vector

0421U103225

Mishchenko Oleksii V

Development of the theory of formation and reduction of the transverse wall thickness variation of cold-rolled tubes from titanium alloys

0521U101599

Borovik Pavel Vladimirovich

Development of theoretic foundations and improvement of technology and equipment of separation operations processes in rolling production

0521U101565

Hrudkina Natalia

Development of energy methods for the analysis of technological modes and improvement the processes of precise volumetric stamping by extrusion.