Bergeman G. Development of the methods for calculation of the developed roll pass design and working out the efficient technology of the channel manufacture

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0408U003974

Thesis Registration Form

0408U003974.pdf

Applicant for

Specialization

  • 05.03.05 - Процеси та машини обробки тиском

17-06-2008

Specialized Academic Board

Д 08.084.02

National Metallurgical Academy Of Ukraine

Essay

The subject of the thesis is improvement of technology for rolling channels using the new scheme of roll pass design. In the present paper the experimental investigation of the metal shape change while rolling channels №№ 8П, 20П...24П was carried out. A special attention was given to the problem of the metal shape change in the pair of the last passes with curved and right flanges as well as to the possibility of securing the necessary dimensions of the shape. A new method has been developed for building and calculation of the developed roll pass design. A theoretic analysis of the energy and power as well as kinematic parameters of rolling in the developed channel passes had been carried out. The method of calculation of the energy and power parameters of rolling in the developed passes had been developed. The increase of productivity and widening of the rolled stock had been obtained in the mill 550 of the open joint-stock enterprise "Dnipropetrovs'ki Petrovski metallurgic works". Key words: channel, developed roll pass design, method of calculation, rolls, energy and power parameters, productivity.

Read more

Files

AREF--автореферат.doc

AREF--обложка.doc

DIS--VVed.doc

DIS--Vivod.doc

DIS--ОБЛОЖКА.doc

DIS--приложения--Прил А.doc

DIS--приложения--Прил Б.doc

DIS--приложения--Прил В.doc

DIS--раздел 1--лит. обзор.doc

DIS--раздел 2--2.1-2.5.doc

DIS--раздел 3--3.1-3.5.doc

DIS--раздел 4--4.1-4.2.doc

DIS--содержание.doc

DIS--ссылки.doc

Similar theses

0424U000044

Andrii Shtuts

Improvement of rolling stamping processes on the basis of modeling of the mechanics of forming blanks

0421U103937

Glazko Vladyslav V

The improvement of the design of the elastomeric compensator for eccentric loads of the "press-die" system with parallel transfer of the technological force vector

0421U103225

Mishchenko Oleksii V

Development of the theory of formation and reduction of the transverse wall thickness variation of cold-rolled tubes from titanium alloys

0521U101599

Borovik Pavel Vladimirovich

Development of theoretic foundations and improvement of technology and equipment of separation operations processes in rolling production

0521U101565

Hrudkina Natalia

Development of energy methods for the analysis of technological modes and improvement the processes of precise volumetric stamping by extrusion.