Grynkevych V. The direct sulution methods of the metal forming boundary value problems and development of forging and metal forming technology

Українська версія

Thesis for the degree of Doctor of Science (DSc)

State registration number

0506U000267

Thesis Registration Form

0506U000267.pdf

Applicant for

Specialization

  • 05.03.05 - Процеси та машини обробки тиском

18-04-2006

Specialized Academic Board

Д 08.084.02

National Metallurgical Academy Of Ukraine

Essay

The thesis is dedicated to development of new methods of the metal forming boundary value problems, which one allow to determine kinematics and stress-strained state of metal in any given boundary point of plastic deformation zone at reduction or exception of iterations, including, in real-time deformation mode. The experimentally computational method of definition of the stress state components in arbitrary boundary points of the plastic deformation zone without flow characteristics input data on velocity vector components has been designed. The method of boundary value metal forming problems solution, which one allows to determine velocity and stress vector components in arbitrary boundary dots of the plastic deformation zone under condition of the boundary conditions correct definition has been designed. Improved technology of fabrication of a small and very small diameter railway wheels also forming technology of aero-engines details has been justified and designed.

Read more

Files

aref.doc

dis1.doc

dis10.doc

dis11.doc

dis12.doc

dis2.doc

dis3.doc

dis4.doc

dis5.doc

dis6.doc

dis7.doc

dis7.doc

dis8.doc

dis9.doc

Приложения--П Р И Л О Ж Е Н И Я.doc

Приложения--Приложение_А.doc

Приложения--Приложение_Б.doc

Приложения--Приложение_В.doc

Приложения--Приложение_Г.doc

Similar theses

0424U000044

Andrii Shtuts

Improvement of rolling stamping processes on the basis of modeling of the mechanics of forming blanks

0421U103937

Glazko Vladyslav V

The improvement of the design of the elastomeric compensator for eccentric loads of the "press-die" system with parallel transfer of the technological force vector

0421U103225

Mishchenko Oleksii V

Development of the theory of formation and reduction of the transverse wall thickness variation of cold-rolled tubes from titanium alloys

0521U101599

Borovik Pavel Vladimirovich

Development of theoretic foundations and improvement of technology and equipment of separation operations processes in rolling production

0521U101565

Hrudkina Natalia

Development of energy methods for the analysis of technological modes and improvement the processes of precise volumetric stamping by extrusion.