Stoyko I. Technological equipment for treatment accuracy of curvilinear axes based in three centre holes

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0404U000903

Thesis Registration Form

0404U000903.pdf

Applicant for

Specialization

  • 05.02.08 - Технологія машинобудування

17-02-2004

Specialized Academic Board

К 58.052.03

Ternopil National Technical University named after Ivan Puluj

Essay

The main schemes of the parts location on the turning and grinding equipment in three centres the possible accuracy of the part geometric axes crossing angle under different ways of location, are analyses as well as the dependencies for the calculation of the integration tolerances, are reasoned. The main methods of fixtures-part subsystems balance is analyzed. The engineering method of technological process design with ca location in tree centre holes, design of technological equipment for treatment in tree centers, was developed.

Read more

Files

1_VSTUP.doc

2_ROZDIL1.doc

3_ROZDIL2.doc

4_ROZDIL3.doc

5_ROZDIL4.doc

5_ROZDIL4.doc

6_WISNOVKU.doc

7_Literatura.doc

8_DODATKU.doc

8_DODATKU.doc

AREF.doc

Similar theses

0423U100054

Vyshnepolskyi Yevhen V.

Improving the quality of gas-turbine engine parts produced by selective laser sintering by means of diamond smoothing

0422U100019

Kostyuk Sava A.

Technological support for increasing the working capacity of the fingers of spherical joints by static-impulse processing

0521U102097

Ihor V. Shepelenko

Scientific bases of technology of drawing antifriction coating with use of plastic deformation

0521U101935

Kusyi Yaroslav Markiyanovych

Scientific and applied basics of the technological inheritability of the quality parameters for providing of the products operation characteristics

0521U101885

Gurey Volodymyr I.

Scientific and technological bases of improving the quality and operational characteristics of machine parts by forming strengthened nanocrystalline layers