Korovina I. Constructing of a surfaces of a constant mean curvature on the set lines of of incidence

Українська версія

Thesis for the degree of Candidate of Sciences (CSc)

State registration number

0412U000846

Applicant for

Specialization

  • 05.01.01 - Прикладна геометрія, інженерна графіка

12-04-2012

Specialized Academic Board

Д26.056.06

Essay

Dissertation on competition of scientific degree of the candidate of engineering science after speciality 05.01.01 - applied geometry, engineering graphics. - Kiev National University of Building and Architecture, Kyiv, Ukraine, 2012. Dissertation is devoted development of methods of geometrical design of minimal surfaces and surfaces of rotation of constant mean curvature based on lines of incidence. Minimal surfaces are built on the basis of equalizations of spatial isotropic curves for finding of parametrical equalizations of which two methods are founded. Parametrical equalizations and type of minimum surfaces for which for an initial curve the curve of slope is taken are found. As the task of constructing of surface of rotation of constant mean curvature can be erected to the task of finding its meridian, a kind and equalization of these curves is found by numeral methods and in a parametrical kind. Theoretical results are used for planning of profile of car's the bulb of high pressure which takes seat spare wheel and design of cuts of awnings of cylinder shells.

Files

Similar theses